Hello,
Just upgrade my 9rx pro with this new release.
- servos limits for all models are adjusted by default to 10 instead of 100.
- all the sounds previously used with the older realeases are not working. Even the bip. looks like a sampling issue and instead you have a kind of very blury and noisy sounds at different speed (quicker). After a while no more sounds at all and looks like the sound decoder is freezing. Did a quick test with other sounds with different sampling freq and same issue (have tried 16k and 32k without any success). Previously i was using ulaw wave with 32k sampling frequency and was working fine.
Cheers
2.0.10 release : servo limits and sounds issues
-
- Posts: 3
- Joined: Wed Sep 10, 2014 6:37 am
- Country: -
Re: 2.0.10 release : servo limits and sounds issues
Thanks, both already reported and with fixes underway (see github issues).
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: 2.0.10 release : servo limits and sounds issues
The sound issue seems a gcc 4.8 bug, I have found a workaround. The limits issue is mine and fixed. Tests in progress, release later today.
-
- Posts: 3
- Joined: Wed Sep 10, 2014 6:37 am
- Country: -
Re: 2.0.10 release : servo limits and sounds issues
Hi,
many thanks for the new release. Just installed on my radio and so far everything is back.
-Sounds and Bip are working (Using 32K ulaw waves)
-Servo limits are now ok (Just test it with my quadcopter).
-FRSKY Cable D telemetry is working for TX/RX (Dont have a hub and i am not using A1/A2 , so i cannot test).
Will provide any feedback if necessary.
Cheers
many thanks for the new release. Just installed on my radio and so far everything is back.
-Sounds and Bip are working (Using 32K ulaw waves)
-Servo limits are now ok (Just test it with my quadcopter).
-FRSKY Cable D telemetry is working for TX/RX (Dont have a hub and i am not using A1/A2 , so i cannot test).
Will provide any feedback if necessary.
Cheers
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: 2.0.10 release : servo limits and sounds issues
Meanwhile we found another issue on arm 4.8 compiler, I suggest you download again the firmware 2.0.11 and check again, I will remove my hack later as I don't think we will switch to 4.8 without a lot of tests ...
-
- Posts: 3
- Joined: Wed Sep 10, 2014 6:37 am
- Country: -
Re: 2.0.10 release : servo limits and sounds issues
Thanks Bertrand ,
i will reload it tonight and will provide you feedback
i will reload it tonight and will provide you feedback