Hi all, first post here, so be gentle.
I've just finished updating Eepe and Er9x to the latest versions (392 and 809) and have discovered that when the eeprom from the 9X tx is copied into Eepe the values of the throttle and elevator trims are transposed. If copied back to the tx it works ok, i.e. the trims resume their original values, so is this just a display problem or something I should be concerned about? I've searched, but couldn't find anything about this on the forum.
Cheers, John.
elvator and throttle trims swapped
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: elvator and throttle trims swapped
What stick mode are you using?
I'll have a look. It is probably just a display problem.
Mike.
I'll have a look. It is probably just a display problem.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: elvator and throttle trims swapped
Mode 2. Thanks for checking it out.
John
John
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: elvator and throttle trims swapped
Should be fixed in the next revision of eepe (and eepskye).
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: elvator and throttle trims swapped
Cheers Mike. Now that's service!
Thanks for all your work on this project,
John.
Thanks for all your work on this project,
John.
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: elvator and throttle trims swapped
I've posted test versions of the next release of er9x and eepe here: http://openrcforums.com/forum/viewtopic ... 598#p64969. The trim swap bug should be fixed. To use the eepe, you need to just copy the eepe.exe file from the .zip to where you have eepe installed. As always, take a backup copy of the existing eepe.exe "just in case".
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!