noobie question
noobie question
hi Im trying to learn about eePe , when I open up eePe Editing model page [set up] at the bottom it says version 0 with a tab that says update to version 2 , my question is what does this mean, what am I updating ? Also is there a good tutorital on using eePe Anywhere. Bert
- MikeB
- 9x Developer
- Posts: 17996
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: noobie question
I recently did a major change to the EEPROM of er9x, including code in er9x to automatically update from "version 0" to "version 2".
This option in eepe allows you to do this change as eepe defaults to "version 0" for backward compatibility.
I think it is from r803 onwards that you have a "version 2" EEPROM.
Mike.
This option in eepe allows you to do this change as eepe defaults to "version 0" for backward compatibility.
I think it is from r803 onwards that you have a "version 2" EEPROM.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: noobie question
Ok thanks mike I understand now.