I have fitted a 6 position switch in place of pot 3 for use with my APM in my Skywalker. How can I use this switch when flying my non APM, powered Glider?
The pots are divided into 6 divisions ranging from -100 to +100.
If I can make pot 3 -75 equal to phase one and pot 3 -50 equal to phase two etc. that would do it.
Alternatively, assigning the various divisions to custom switches would also work.
At present I'm using it as an alternative throttle control which is a waste as the original pot would work just as well for this.
I'm new to open9x, I previously used er9x and changed over in the hope that open9x would provide an answer to this problem.
I hope someone can help.
John.
PS. I'm also not that great on er9x.
J.