Hey guys,
I flashed Turnigy 9x with er9x but I can't calibrate the sticks - when I'm on the Calibration screen and I press the [MENU] button the main screen returns thus no calibration is possible. Maybe it refuses to calibrate because of the startup warning saying "Throttle not idle \n Reset throttle"?
I made a short video to be clear:
[BBvideo 425,350]http://www.youtube.com/watch?v=yrcJLxwX3K0[/BBvideo]
Pressing [MENU] on "Calibration" returns to main screen
- c0dehunter
- Posts: 9
- Joined: Sun May 12, 2013 10:44 pm
- Country: -
Pressing [MENU] on "Calibration" returns to main screen
Last edited by c0dehunter on Thu Jun 13, 2013 9:46 pm, edited 2 times in total.
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Pressing [MENU] on "Calibration" returns to main screen
That is not normal! It should accept calibration.
How have you connected the programmer? I ask because one of the programming signal (SCK) uses the same pin as the MENU button so you might have some problem there.
Mike.
How have you connected the programmer? I ask because one of the programming signal (SCK) uses the same pin as the MENU button so you might have some problem there.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- c0dehunter
- Posts: 9
- Joined: Sun May 12, 2013 10:44 pm
- Country: -
Re: Pressing [MENU] on "Calibration" returns to main screen
Yeah, that was the problem! I had soldered SCK wire bad. I fixed it now and I can calibrate. Thanks!