I have a big problem with my 9XR.
Today i flashed..or wanted to flash my 9XR with open9x with a usbasp like in the Video:
https://www.youtube.com/watch?v=x_yDfl7fuSw
Everything went fine exept at the end of the verify part. There was an errormessage that the first byte(s) are not correct. Or somethink like that.
unfortunately i dodnt wrote down the error.
Now my 9xr doesn´t turn on anymore. The display remains off. Only the "ready" is powerd and im not able to flash the 9XR again. There is allways the message
that the target does not answer:
Code: Select all
avrdude.exe: error: programm enable: target doesn't answer. 1
avrdude.exe: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
Did i kill my 9xr? or is there a chance/way to get them back to life?
i removed the r8 resistors on the programmer cause they were 200 Ohms and i tried to burn the firmware
with an arduino programed as a IPS
Code: Select all
avrdude.exe: stk500_getsync(): not in sync: resp=0x00
Thanks a lot for the help in advance.
Chris