Is this possible? Using 2.2 on taranis x9d+, bi-directional ESC on throttle stick. Set ESC neutral when throttle is down at bottom of travel. Throttle up to top of travel is ESC 100% forward. Use a switch to reverse where throttle down to bottom is still ESC neutral and throttle up is now ESC 100% reverse.
ESC calibration could be throttle all up for 100% forward, throw switch with throttle all up for 100% reverse, throttle all down for neutral.
Possible? Throttle down is neutral on fwd/rev ESC & use switch to reverse direction?
Re: Possible? Throttle down is neutral on fwd/rev ESC & use switch to reverse direction?
Yes this is possible. If you sey weight to 200 and offset to -100 you will get output of 0 to 100 on one mixer row. Make this row active be a switch up. Theb create a second nixer row on the same channel and create weight -200 and offset 100. Active this mixer with the switch down. This will then be 0 to -100
Re: Possible? Throttle down is neutral on fwd/rev ESC & use switch to reverse direction?
Thanks for the explanation! The options of this system are a bit overwhelming. I will give this a try.
Re: Possible? Throttle down is neutral on fwd/rev ESC & use switch to reverse direction?
Be aware, that, at any time, you can switch your motor from full forward to full reverse!!
There was a similar question already here
viewtopic.php?f=96&t=13001
maybe it helps
Reinhard
There was a similar question already here
viewtopic.php?f=96&t=13001
maybe it helps
Reinhard