TH 9X - GRAVE ERROR IN FLIGHT 3D HELI
TH 9X - GRAVE ERROR IN FLIGHT 3D HELI
Recently I bought a Turnigy 9x, very good, but I found a serious error in his memory, in helicopter mode, to do 3d flight. item in the reverse curve, which sets the reversal of the servo motor, to fly back, when applied to the idle, the engine is accelerated when the pit falls or rises. detail that applies when the feature, the reverse signal is given pro rudder servo, which is a serious error, which causes a decrease in case of resource use, and that precludes flying heli 3d mode. if they can tell me if this error was already corrected, may still be with my radio firmware antidote, but bought only 60 days, and arrived about 3 days, and found that, waiting for help.
- cre8tiveleo
- Posts: 1434
- Joined: Tue Dec 27, 2011 6:13 pm
- Country: -
- Location: Ontario,(GTA North)
- Contact:
Re: TH 9X - GRAVE ERROR IN FLIGHT 3D HELI
Running stock firmware?
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: TH 9X - GRAVE ERROR IN FLIGHT 3D HELI
Not sure we will be able to help. The stock firmware is 'closed source' so we cant fix any bugs.
My suggestion is to swap to one of the open source ones. (which are much better)
Rob
My suggestion is to swap to one of the open source ones. (which are much better)
Rob
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
Re: TH 9X - GRAVE ERROR IN FLIGHT 3D HELI
I reset the program and worked correctly, but I'll buy the cable and update it.
For now problem solved!
Thank you.
For now problem solved!
Thank you.
Re: TH 9X - GRAVE ERROR IN FLIGHT 3D HELI
I reset the program and ran two veses normal to happen again I'll update it. problem solved for now. thanks for the help.