Hi,
The tranceiver of the Turnigy th9 do not send. The binding proces is wel OK, but after that it goes wrong.
Nothing works; no motor, no servo reacts on the sticks. Either nothing works!
The battery's etc are also OK.
Can anyone tell me where to look at. What can be the problem?
Thanks
Gerritu
TH9x don't send
-
Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
TH9x don't send
is your tx running er9x?
Just wondering if you simply don't have any mixes assigned yet?
Sent from my iPhone using Tapatalk
Just wondering if you simply don't have any mixes assigned yet?
Sent from my iPhone using Tapatalk
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
-
GrootWitbaas
- Posts: 358
- Joined: Tue Dec 27, 2011 8:57 pm
- Country: -
- Location: Germany
Re: TH9x don't send
Check you PPM pin to the module ...it was reported by someone that this pin was not connecting (bad solder) would be the 1st place I look independent of firmware. next it depends on what you have firmware wise ...in er9x there are options so if you have selected pxx with a stock module it won't work ...
General trouble maker and wannabee Dev