I managed to brake R10 while trying to solder the haptic feedback VCC wire!!!!!!!!!!
FrSky does not provide Taranis board schematics and I need find r10's value asap so I could try fix it using a standard 1/8 or 1/4 watt resistor with leads.
Please someone let me know which resistor I can use there, I don't have a spare radio and I cannot fly until mine is fixed!
Need help ASAP please!
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Need help ASAP please!
10K
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Need help ASAP please!
Thank you so much Mike!! I do have these and I will try to install it right away.
Re: Need help ASAP please!
Hey Mike, thank to your information I fixed the issue, the haptic motor is installed, firmware is upgraded and I have the new companion but I could not make the haptic feedback work
I do have it enabled to ALL in general settings. Would you please give an example on how to activate it?
I loaded an eppron from the radio containing my models and went to general settings and checked haptic if this makes difference, but nothing happens.
Thanks again
I do have it enabled to ALL in general settings. Would you please give an example on how to activate it?
I loaded an eppron from the radio containing my models and went to general settings and checked haptic if this makes difference, but nothing happens.
Thanks again
Re: Need help ASAP please!
Make sure haptic strength is not set to 0.