Hello i have a Pro mini 3.3V. I'm using 2x NTC sensors from Frsky ( the ones sold with their S.port RPM Temp sensor). I'm using 2x 100k ohm resistor from VCC--100k--A0 and one VCC--100k--A1. The sensors are connected to GND and A0 and A1 respectively. D8 i used to read RPM and i use also a 10K resistor from CDI signal (rcexl) of a gas engine to D8 the other wire from CDI i connected to GND.
I setup Baisc and advanced config as attached. I can read only one temperature (VOLt_1 -- A0) and i don't know where to change to show all 2 values. The temp showed on A0 is correct as ambient temperature.
Also where can i change the name of the value in the display of the radio? I want to see TempDX and TempSX if possible. And avoid to see not used one like RelAlt.
Thanks
Adriano
openxsensor jeti dual temp and rpm
Moderator: rainer
-
- Posts: 9
- Joined: Fri Aug 25, 2017 11:47 am
- Country: -
openxsensor jeti dual temp and rpm
- Attachments
-
- oXs_config_advanced.h
- (16.85 KiB) Downloaded 156 times
-
- oXs_config_basic.h
- (11.73 KiB) Downloaded 163 times
-
- Posts: 9
- Joined: Fri Aug 25, 2017 11:47 am
- Country: -
Re: openxsensor jeti dual temp and rpm
I looked at description file and oXs_out_jeti.h It seems that if i want to use 2 NTC probe for dual temp i need to use 2 separate Arduino boards.
I'm right? Dual temp are only for some protocols like Frsky or Hott?
Thanks
I'm right? Dual temp are only for some protocols like Frsky or Hott?
Thanks