I have a Beier USM-RC-16 soundand light module which have a EKMFA mode where it takes pulses to control a feature.
Example:
I have to flip the switch 3 times forward and one function is triggered.
I then flip the switch 5 times forward and another function will react.
I will like it to be put on the different switches on the radio, so example the SA will send 2 pulses, the SB will send 3 pulses and so on.
The length of the pulses must be 100mS.
Sending different pulses with a switch
Sending different pulses with a switch
--
Leonard, Denmark
http://rc.leonard.dk/
Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU
Leonard, Denmark
http://rc.leonard.dk/
Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU
Re: Sending different pulses with a switch
Don't hurry, I think I have a solution-
I will post it here later today or tomorrow.
I will post it here later today or tomorrow.
--
Leonard, Denmark
http://rc.leonard.dk/
Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU
Leonard, Denmark
http://rc.leonard.dk/
Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU
Re: Sending different pulses with a switch
Playing and testing with logical switches and the Timer function it now works.
And I also learned a lot other things about making the different switches to do special things.
It is getting better and better
And I also learned a lot other things about making the different switches to do special things.
It is getting better and better
--
Leonard, Denmark
http://rc.leonard.dk/
Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU
Leonard, Denmark
http://rc.leonard.dk/
Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU
Re: Sending different pulses with a switch
Yes, this is an old post, but I have same problem, how did you do it using the logical switch timer function?
Re: Sending different pulses with a switch
I'm also very interested how you solved this. Can you share it ?