3 position Flaps
3 position Flaps
I set up 3 position flaps as follows. On the mixer menu, i used channel 5. Source 3POS. Weight 100. Offset 0. Switch ---, multpx Replace. Go to main screen and cycle through views until you see the 8 slider bar view. Watch the top right (5) move from full left to null to full right as you go from ID0, ID1, to ID2 positions.
Re: 3 position Flaps
hi i tried this but cannot find any section named mixer, on mine there is a menu named PROG which shows 3 choices of mix but even in there it does not give a option for the three position switch which i want to use any one know how to do it?
regards Poppy Ann
regards Poppy Ann
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 3 position Flaps
PoppyAnn: Is this with the stock firmware or have you flashed an alternative?
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 3 position Flaps
this is with the stock firmware, i am not sure which version it is, on the main board it says ver 1.5 i think, it is printed so small i can hardly make it out.
thanks for your help.
Poppy Ann.
thanks for your help.
Poppy Ann.
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 3 position Flaps
You've posted your question in the custom firmware area. The stock firmware isn't very good I understand, I actually never used it.
Seriously consider upgrading to one of the custom firmwares, they are so much more powerful.
Mike.
Seriously consider upgrading to one of the custom firmwares, they are so much more powerful.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 3 position Flaps
sorry about posting in the wrong place, i just saw the post for using the 3 position switch and asked the question, when i can i will try flashing the latest firmware i just have to buy the bits to connect the transmitter to the computer.
regards Poppy Ann.
regards Poppy Ann.