openrcforums

Have you managed to take RSSI signal from FrSky V8R7-II receiver? There are many manuals for doing that with V8FR-II, in most cases using simple RC filter, but none of them shows that one could do the same with V8R7-II receiver. Do you have any schematics/photos showing place where i should solder that RC filter in this receiver? Are in this case also two variants of soldering points, giving different voltage range values on output?
What are proper parameters of R & C values in that filter? In all cases C=10uF, but R differs from 10k to 4k7 ohms. Which should I use?