9Xtreme FrSky Haptic Upgrade Mod

Post Reply
User avatar
bob195558
Posts: 2376
Joined: Sun Dec 16, 2012 7:24 pm
Country: United States
Location: New England, Vermont
Contact:

9Xtreme FrSky Haptic Upgrade Mod

Post by bob195558 »

9Xtreme FrSky Haptic Upgrade Mod

Wiring connections for the 9Xtreme Expansion Grid:
1) Pin 10: +3.3V
2) Pin 12: Haptic Out Signal
3) Pin 13: -GND
9Xtreme Ex Grid pads_c.jpg
9Xtreme Expansion Grid Wiring Connections.
9Xtreme Expansion Grid Wiring Connections.
FrSky Haptic
FrSky Haptic Upgrade
FrSky Haptic Upgrade
Add wires to FrSky Haptic Upgrade
FrSky Haptic Wires added.
FrSky Haptic Wires added.
Hot Glue Haptic to Case..jpg
I bent the expansion grid pins at about 45 degrees so that the two case halves will fit together.
FrSky Haptic Upgrade Mod_a.jpg
Bob B.
Last edited by bob195558 on Sat Feb 13, 2016 1:27 pm, edited 1 time in total.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).

User avatar
jhsa
Posts: 19480
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: 9Xtreme FrSky Haptic Upgrade Mod

Post by jhsa »

Very nice job Bob. For the ones that like to build stuff, I built my own driver, and installed 2 motors. One on each side of the radio. Not very difficult..

viewtopic.php?f=126&t=7987

João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Post Reply

Return to “9Xtreme upgrade board”