Page 1 of 1
Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 7:52 am
by bertrand35
Here it is. The code is ported from gv9x. Please tell-me if it works, I don't own the module to test myself...
Thanks,
Bertrand.
Re: Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 5:56 pm
by uphiearl
Screen 1 INFOS is correct so 38kb is working. I see the APM2 boot up properly and get the heartbeat indication
Screen 2 does not display any data. all fields are 0
Screen 3 is getting proper data.
Earl
Re: Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 6:17 pm
by bertrand35
So no GPS information, right?
Bertrand.
Re: Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 6:25 pm
by uphiearl
went back to gv9x109dump and all is ok.
btw...i did not notice a baud rate selection
earl
Re: Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 6:27 pm
by uphiearl
just no gps info. baud must be 38kb cause that is whay my xbees do.
earl
Re: Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 6:32 pm
by uphiearl
i would like to see the display screens more like my old stile with double character hight and 10 screens. easier to read at a glance.
earl
Here is old post
http://diydrones.com/profiles/blogs/tel ... -tx-screen
Re: Binary with Mavlink extension for beta testing
Posted: Sat Mar 24, 2012 7:19 pm
by bertrand35
uphiearl wrote:just no gps info. baud must be 38kb cause that is whay my xbees do.
earl
Ah ok, good explanation, I didn't ported it ...
I will do next week then.
Bertrand.