Can't get my HighPrec Vario to peep!

[ftherrmann]

Hello All!

Got my Taranis yesterday and everything works except the high precision Vario. The GPS sensor works fine, all 5 receivers range checked and are delivering telemetry.

Here’s how I have the Vario set which I’m pretty certain is correct:

CF1 Up Arrow Vario

I’ve got the Vario sound turned up and I’ve selected Vario as the “Source” under the Telemetry page. The recommended sensitivity is 0.3. I’ve dropped it all the way down to .1 and can’t get a peep out of it. It blinks, but won’t respond to any type of movement or blowing air on it. If I set the sensitivity to 0.0 the transmitter sounds off pretty much continuously. I also reset the telemetry page and entered my settings again.

In short: The Vario Blinks but doesn't respond to any type of pressure change. Me thinks it's defective.

TIA

Fred

[ftherrmann]

Never mind. Figured it out and all is well! Thread closed...

[jhsa]

Would you mind sharing how you fixed it with us?

Thanks.

João

Sent from my GT-I9195 using Tapatalk