openrcforums

Hi,
I read lot of info about this but i´m a bit confused ( read about two receiver, or PXX only 8 chanels...)
Is possible now get 16 channels working in PXX mode with this config?

TX:
Th9x r809
Module XJT frsky

RX:
X8R-->sbus converter--> Flight controller Mikrokopter
I made several test and only get working PXX 8 channels in my th9x.

Thank you very much
Jose A.

Have you set the sub type to D16?

Mike.

I've just checked and PXX -> XJT -> X6R for 16 channels and it works OK. I configured the X6R to output channels 9-14 and it worked OK.

Mike.

Thank you very much for your help, Mike.
You point me in the correct way...
The sbus to ppm converter has a jumper if install output chanels 1-12; if no present only channels 1-8 are output.
These are my fault to get more than 8 channels
Thank you again
Best Regards.
Jose A.