openrcforums

Hi all.

As well as flying EP models, I also fly gliders. I would like to assign the spoiler/camber mix to one of the slider switches on the side of the case......but cannot find anything in the switch assignments, that tells you how to use them ??.

Maybe its just an oversight by me........I dunno ?.

I do have spoilers and camber set up on SB and SG........but would prefer one of the sliders

Can anyone help ??.

Thanks,

Steve.

Its not a switch

It is a bit more like a POT, so you work with it in a different way.

Use the mix source of LS or RS to access them.

Hi Rob.

Thanks for that........on my previous radios, they were known as slider switches !.

Where do I find them in the programming though........I can't see them listed anywhere ?.

Set your MIX source to LS or RS

e.g. Normally you add a mix with the source of THR, MAX, AIL, etc...

Same place

found it, many thanks

Steve71 wrote:Hi Rob.

Thanks for that........on my previous radios, they were known as slider switches !.

Where do I find them in the programming though........I can't see them listed anywhere ?.

Never heard them called switches. They've always been sliders any time I've encountered the term.

Why are RS and LS not supported on TX companion?

drummaker wrote: ↑Fri May 19, 2017 4:35 pm Why are RS and LS not supported on TX companion?

They are and have been for years. What radio and Companion version? And what are you trying to do?

Jim

sorry about the delay 2.2 is the version

You cannot find them in drop down in most places

Then you need to check they are enabled in the hardware page of radio settings.