Hi,
To make the question in my last post easier and more directly. I guess it's possible, but how do you use one of the switches to switch between two channels? For example: The switch is in possition 1, throttle controls ch1 and when switch is in possition 2, throttle controls ch2.
Regards,
Lars R.
Mixing - er9x
Re: Mixing - er9x
Gear switch [Switch(GEA)] is only used as an example. Any switch can be used.
Switch(GEA) is active when the physical switch is ON, Switch(!GEA) is active, when the physical switch is OFF
If the switched off channel should be on neutral then do:
CH1 +100%THR Switch(!GEA)
CH2 +100%THR Switch(GEA)
If the switched off channel should go to a predefined value then do:
CH1 -100%Full
R +100%THR Switch(!GEA)
CH2 -100%FULL
R +100%THR Switch(GEA)
In the second example the FULL mix defines the value when the second mix line is inactive.
The second mix line is a 'Replace' mix that, when active, replaces the result of the foregoing mixe lines of that channel.
Reinhard
Switch(GEA) is active when the physical switch is ON, Switch(!GEA) is active, when the physical switch is OFF
If the switched off channel should be on neutral then do:
CH1 +100%THR Switch(!GEA)
CH2 +100%THR Switch(GEA)
If the switched off channel should go to a predefined value then do:
CH1 -100%Full
R +100%THR Switch(!GEA)
CH2 -100%FULL
R +100%THR Switch(GEA)
In the second example the FULL mix defines the value when the second mix line is inactive.
The second mix line is a 'Replace' mix that, when active, replaces the result of the foregoing mixe lines of that channel.
Reinhard
Re: Mixing - er9x
And of course it works smooth once again. Thank you very much Reinhard, much appreciated:)