Did you notice that your 10% ele only gets added in mode ID0 ? If you wanted it to work in the other modes also, you need to move that mixer line down one. So it would be like this:
Code: Select all
CH03
(+125%)Thr Switch(ID0) Curve(C1)
R(+125%)Thr Switch(!ID0) Curve(C2)
(+10%)Ele Switch(ELE)
R(-100%)Max Switch(THR)
I have to ask (now that I noticed), which version of Er9x are you using? Max was changed to half a long time ago.
Also I would change your throttle from 125% to 100% and just use the curves to control the throttle channel output. With them set to 125%, channel 3 output gets to the highest point on the curve before your throttle stick moves as far as it can.
-Gohst