Hello,
I've been running the Sky9x board on other cases and so far I've stuffing all the stuff inside, icluding the back and switch/buzzer board. The result is quite horrible looking mess, it works but a PITA to install/adjust.
Now, I'd like to make cleaner installation without back and switch board but I can't really figure out a sensible way from the schematics as the power connections are quite complicated between the boards.
So I's like to ask a little help, how to make this simple way? I just need to attach the battery and a on/off switch.
Running Sky9x board without 9x back and switch boards
Re: Running Sky9x board without 9x back and switch boards
Here are the connections needed.
-Brent
-Brent
Re: Running Sky9x board without 9x back and switch boards
Thanks a lot Brent.