Starting and Ending G-codes for your Slicer (3D-Printer CR10)
Posted: Sat Aug 27, 2022 10:51 am
Starting and Ending G-codes for your Slicer
This is what I use in my Slicer (Simplify 3D V4.1.2) with the hardware-upgrades of my CR10 Printer.
TH3D EZABL
Starting G-codes:
M75 ; Start Timer and Engage Filament Monitor
G28 ; home all axes
G29 ; auto level
G4 S10; wait for heaters to recover
G1 X0 Y20 Z0.2 F3000 ; get ready to prime
G92 E0 ; reset extrusion distance
G1 F200 E25 ; extrude filament
G92 E0 ; reset extrusion distance again
M420 Z1 ; fade ABL off after 1mm
Ending G-codes:
91
G1 F1800 E-3
G1 F3000 Z10
G90
G00 X290 Y290 ; finish position x and y axis
M106 S0 ; turn off cooling fan
M104 S0 ; turn off extruder
M140 S0 ; turn off bed
M84 ; disable motors
Also for more info go to: viewtopic.php?f=129&t=11963
This is what I use in my Slicer (Simplify 3D V4.1.2) with the hardware-upgrades of my CR10 Printer.
TH3D EZABL
Starting G-codes:
M75 ; Start Timer and Engage Filament Monitor
G28 ; home all axes
G29 ; auto level
G4 S10; wait for heaters to recover
G1 X0 Y20 Z0.2 F3000 ; get ready to prime
G92 E0 ; reset extrusion distance
G1 F200 E25 ; extrude filament
G92 E0 ; reset extrusion distance again
M420 Z1 ; fade ABL off after 1mm
Ending G-codes:
91
G1 F1800 E-3
G1 F3000 Z10
G90
G00 X290 Y290 ; finish position x and y axis
M106 S0 ; turn off cooling fan
M104 S0 ; turn off extruder
M140 S0 ; turn off bed
M84 ; disable motors
Also for more info go to: viewtopic.php?f=129&t=11963