I'm still learning my Taranis plus 2019.
I have several MicroAces models, each having an all-in-one block receiver with a couple of linear servos and a speed controller on the board. These bound to my older Taranis plus no problem, and I was using internal RF mode "D8" in the Tx. I've discovered that this setting is missing in my 2019 Tx - I have internal RF modes ACCESS and ACCST D16 only. My "normal" FrSky receivers are working on ACCST D16.
Is there any way to get D8 on the 2019 Tx?
Thanks.
What do we used for "D8"
Re: What do we used for "D8"
Only with an external module
Re: What do we used for "D8"
OK, thanks Kilrah. Seems like another step backwards with the 2019 Tx! With this and the EEPROM memory warning that you also helped me with, I think I'm going to have to split my models into two groups, so the D8 models can remain with my older Taranis plus and the newer and bigger ones with the new 2019.