just replaced the Traxxas TQi in my Traxxas Scale Crawler...
it had a function where if you pressed a momentary contact switch, the throttle would hold where it was at the time,
but also be adjustable via a pot control.
Is this a possibility on the Taranis X9D+?
thanks for looking...
Setup a throttle hold but adjustable?
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Setup a throttle hold but adjustable?
Should be possible. The main thing you need is a couple of mixes on the throttle channel, e.g. for CH3:
CH3 +100% THR
R CH3 +100% CH3 switch(SA-) [A replace multiplex mix]
With switch SA not in the middle position, then the throttle works normally (first mix line). With SA in the middle position, the second mix line takes over and holds the throttle in the current position.
Mike
CH3 +100% THR
R CH3 +100% CH3 switch(SA-) [A replace multiplex mix]
With switch SA not in the middle position, then the throttle works normally (first mix line). With SA in the middle position, the second mix line takes over and holds the throttle in the current position.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!