Help with Trainer-Input (Radiomaster TX16s, but not only)

openTx has introduced a range of new features, ideas and bling. It is fast becoming the firmware of choice for many users. openTx will run on ALL current hardware platforms, including the gruvin9x and sky9x boards. Work has already started to support the new FrSky X9D radio!
Post Reply
wilopaan
Posts: 131
Joined: Sun Sep 09, 2018 6:09 pm
Country: -

Help with Trainer-Input (Radiomaster TX16s, but not only)

Post by wilopaan » Sat May 23, 2020 6:04 pm

Hi all,

sorry for a perhaps dumb question, becuase I stil did not get it right:

where can I supply digital(SBUS) trainer input?

- to the dsc Jack?
- to pin2 of the module bay?
- to one of the TTL serial ports?

What options do I have to select in OpenTX?

Thank you!


wilopaan
Posts: 131
Joined: Sun Sep 09, 2018 6:09 pm
Country: -

Re: Help with Trainer-Input (Radiomaster TX16s, but not only)

Post by wilopaan » Sun May 24, 2020 11:38 am

Well, is this a difficult question?
Where / on which interfaces can one supply serial trainer input?

wilopaan
Posts: 131
Joined: Sun Sep 09, 2018 6:09 pm
Country: -

Re: Help with Trainer-Input (Radiomaster TX16s, but not only)

Post by wilopaan » Thu May 28, 2020 6:26 pm

Either the question is too simple or just dumb, or it requires a lot of explanation ...

Nobody to give me some clues?

User avatar
MikeB
9x Developer
Posts: 16912
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Help with Trainer-Input (Radiomaster TX16s, but not only)

Post by MikeB » Thu May 28, 2020 6:51 pm

Or nobody reading this knows!
I don't have a T16S so I don't know (and I use erskyTx anyway).

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

wilopaan
Posts: 131
Joined: Sun Sep 09, 2018 6:09 pm
Country: -

Re: Help with Trainer-Input (Radiomaster TX16s, but not only)

Post by wilopaan » Thu May 28, 2020 7:11 pm

MikeB wrote:
Thu May 28, 2020 6:51 pm
Or nobody reading this knows!
I don't have a T16S so I don't know (and I use erskyTx anyway).

Mike
My hope was to reach some of the devs here, because in the past I got very valuable and useful information here.


Post Reply

Return to “openTx”