Upgrading Heat-Bed with High Temperature Neodymium Magnets (CR10 3D Printer)

Projects that are not for RC, but are cool and worthy of development.
Post Reply
User avatar
bob195558
Posts: 2128
Joined: Sun Dec 16, 2012 7:24 pm
Country: United States
Location: New England, Vermont
Contact:

Upgrading Heat-Bed with High Temperature Neodymium Magnets (CR10 3D Printer)

Post by bob195558 » Sat Nov 09, 2019 9:44 pm

Install TH3D High Temperature Neodymium Magnets to the CR10 3D Printer
TH3D High Temperature Neodymium Magnets.jpg
Heat-Bed Upgrade with Neodymium Magnets to hold EZFlex-Sheet with EZMat Sheet

1) Purchase TH3D High Temperature Neodymium Magnets for EZFlex-Sheet.
Note: TH3D Neodymium Magnets have been replaced with EZFlex Magnetic Base,
See here for more info: https://www.th3dstudio.com/product/ezfl ... etic-base/
Also see here for the EZFlex System – Flexible Print Surface Bundle: https://www.th3dstudio.com/product/ezflex-plate-bundle/


Printer Heat_Bed Removed_top side_a.jpg
2) Remove CR10 Heat-Bed by disconnection the power cable and the four leveling adjuster wheels.


Isopropyl Rubbing Alcohol _b.jpg
3) Clean the backside of the Heat-Bed with 91% Isopropyl Rubbing Alcohol


Printer HeatBed_BackSide_c.jpg
4) Attach Neodymium Magnets to backside of the Heat-Bed.

Reassemble HeatBed with EZFlex Sheet _d.jpg
5) Reassemble Heat-Bed with EZFlex-Sheet and make proper adjustment for the next print.



Note: Also I added Cork Tiles to insulate the backside of the Heat-Bed,
see here for more info: https://openrcforums.com/forum/viewtopi ... 85&t=12328
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.

3D Printing upgrades with (CR10 3D Printer): (http://openrcforums.com/forum/viewforum.php?f=85).


Post Reply

Return to “Other Electronic Projects”