I have recently bought a FrSky Neuron 60 ESC.
Now I want to change the BEC voltage because I used HV servos in my glider so I want to set the voltage to 7 Volt.
I do not have this Airlink device so I am trying to use the lua script on my Horus X10.
I have already updated to OpenTx 2.2.4 to get the bec telemetry data and the sensors are found but when I run the script I het an error message. " ?:0. attempt to call field('getSensor' (nil value)
Anybody have a clue what's wrong here?
Setting BEC voltage with Lua script
Re: Setting BEC voltage with Lua script
It looks like you're trying to run a script that is made for OpenTX 2.3
The correct version to use with 2.2.4 is in the SD archive for 2.2.4.
https://downloads.open-tx.org/2.2/relea ... 2V0021.zip
The correct version to use with 2.2.4 is in the SD archive for 2.2.4.
https://downloads.open-tx.org/2.2/relea ... 2V0021.zip
Re: Setting BEC voltage with Lua script
I downloaded this Lua script from the FrSky website.
I will try the one from the OpenTx sd card folder then.
I will try the one from the OpenTx sd card folder then.
Re: Setting BEC voltage with Lua script
Great tip!!
Used the tool that was already in the sd card with OpenTx 2.2.4
It worked like a charm.
Thanks !
Used the tool that was already in the sd card with OpenTx 2.2.4
It worked like a charm.
Thanks !