Trying to setup a switch on my Taranis X9D, V2.2 firmware, that allows me to activate a switch and HOLD THE CURRENT THROTTLE POSITION - useful when learning to hover a helicopter.
I have searched the web endlessly to no avail - plenty of articles on how to program a throttle 'kill' or 'disable' switch, but that is NOT what I am trying to achieve. I need a switch that will simply maintain the throttle signal at the last known throttle stick position until the switch is turned off.
Any ideas?
Programming a throttle POSITION hold with, Taranis
-
- Posts: 2
- Joined: Sun Oct 28, 2018 7:32 pm
- Country: -
Re: Programming a throttle POSITION hold with, Taranis
If your throttle channel is CH3, then below the main line of CH3 add a REPLACE mixer line with 100%CH3 and the switch you want to activate the feature.
You obviously want to be extremely careful when setting this up and using it, and should always have a throttle kill with higher priority.
You obviously want to be extremely careful when setting this up and using it, and should always have a throttle kill with higher priority.
Re: Programming a throttle POSITION hold with, Taranis
Ch03 100% Thr
R 100% CH3 Switch (THR) (R means that this is a replace mix)
João
R 100% CH3 Switch (THR) (R means that this is a replace mix)
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
-
- Posts: 2
- Joined: Sun Oct 28, 2018 7:32 pm
- Country: -
Re: Programming a throttle POSITION hold with, Taranis
Many thanks for the prompt response.
Think I have it sorted now!
Think I have it sorted now!