Page 4 of 4
Re: FrSky FAS-100 Telemetry Amperage Sensor
Posted: Tue May 27, 2014 2:57 pm
by PNaz
I am using a Taranis with your latest test version of ersky9x, X8R receiver, and the FAS100 into a FVAS-02H high precision vario connected to the SPort. I had the same problem with earlier versions of erSkye. The SP-40A amp sensor straight into the SPort does not have a problem.
Paul
Re: FrSky FAS-100 Telemetry Amperage Sensor
Posted: Tue May 27, 2014 11:49 pm
by MikeB
I've managed to hook up the same hardware and create the problem. Then I've sorted the fix as well!
There was some sensor ID mapping for the 'hub' sensors, in hub mode, that wasn't being done for 'hub' sensors in SPort mode.
I need to run some more tests, so I'll post a new test version tomorrow.
Mike.
Re: FrSky FAS-100 Telemetry Amperage Sensor
Posted: Wed May 28, 2014 11:09 am
by MikeB
Test version with this fix here:
viewtopic.php?f=7&t=4676&p=65894#p65894.
Mike.
Re: FrSky FAS-100 Telemetry Amperage Sensor
Posted: Wed May 28, 2014 6:21 pm
by PNaz
A1 is showing the receiver voltage correctly now with the new test version. RxV is showing 0 at all times.
Paul
Re: FrSky FAS-100 Telemetry Amperage Sensor
Posted: Wed May 28, 2014 7:16 pm
by MikeB
RxV should be working. Have you set the range for this? It's on the TELEMETRY menu. Go down to the second page where you set RSSI limits and the range for RxV.
Mike.