openrcforums

Hi Guys
I have been following the youtube video (https://www.youtube.com/watch?v=nZxMvTCN_pI) showing how this can be done with Open TX

ie send the RSSI value back to TX via telemetry return it to the RX via 2.4Ghz then through to the FC and OSD via SBUS

Open TX provides an inputs page to source RSSI but I can find the equivalent step in ErSky9X - is this possible?

I'm using the 9Xtreme with an X6R and the Omnibus F4 flight controller

regards
Hans

Yes!
Use a Scaler. Set the source to RSSI and the multiplier to 10, then use the scaler as the source to a channel mix.
That will get the RSSI value controlling the channel, then you should be able to follow the video instructions to use the channel.

Mike.

Hi Mike
Amazingly rapid response - whats more its positive - ErSky9x provides the answer again
Great work Mike
I'll follow your instructions
Many many thanks
Hans

More due to luck! I just happened to look at the forum having been out most of the day. I didn't notice the time of your post, I was just looking at all posts through the day.

Mike.