openrcforums

Seem I have forgotten how to connect an er9x-M2561 radio to the eepe eeprom editor.
Radio has the SmartieParts Rev-2.4 Programmer and the Rev-1.8 TelemetrEZ boards.
Computers see the USB connection (I hear the USB connecting sound) using the SmartieParts drivers.

The old radio firmware version on this M2561 radio is:
VERS: V1:010-Mike
DATE: 23.05.2015
TIME: 10:13:16
SVN: er9x-r819
MOD: FRSKY 2561

And have tried both my Desk and Notebook computers running Win7 64-bit.
Notebook has eepe Revision: 413, Apr 8 2015
and Desktop has eepe Revision: 419, Jan 8 2016

I have been using the erSky9x firmware and have not used er9x for some time now.
So I have tried several ways to connect to eepe, but I must be doing it incorrectly and/or have my setting wrong.

Bob B.

You have the wrong processor selected. You have the "M1281" selected. You want too select the "m2561"

João

Thank you ! I missed seeing that, it is working correctly now.

Newly updated er9x-M2561 firmware:
Version
VERS: V1.749-Mike
DATE: 30.11.2016
TIME: 13:41:45
SVN: er9x-r820
MOD: FRSKY 2561
------------------------------------------------------------
Added info about 9x-Radio with er9x-M2561 firmware:
How to instructions, to flash new er9x firmware to 9x radios.
1) Down-Load new "er9x for Mega2561 processor (to download right-click and select 'save as')"
firmware to your PC deck-top, find here: (http://www.er9x.com/).
2) Open PC "eepe eeprom editor" on your PC and select proper "eepe Avrdude Configuration"
and "eepe Preferences" settings for your radio.
3) Turn ON your 9x-Radio and connect your "USB cable" (should hear USB connection sound).
4) Then in the PC "eepe eeprom editor" select "Flash Firmware to Tx", a window will pop-up
and you will then find your new firmware to flash and press "open".
(Note: do not turn you 9x-radio off during this process until this process is finished because this will Brick (break) your radio.)
5) When the Flashing process is finished you can disconnect the USB cable and turn you 9x-radio off and back ON again.
6) Check all your eeprom model programs that they all have there proper settings.
............................................................