Page 5 of 5
Re: Build Compile amod [Please help]
Posted: Wed Nov 15, 2017 2:05 pm
by darozas
kmargos wrote: ↑Wed Nov 08, 2017 12:46 pm
Hi Mike,
Do you know if sometimes when connecting the TX the megasound does not work, and that has to turn it off and on again to work?
Marco,
Same here
If I connect radio on and off on quick it stops working.
Then I have to leave radio turned off for like 3 minutes to get it working again.
Regards
Re: Build Compile amod [Please help]
Posted: Wed Nov 15, 2017 4:03 pm
by MikeB
Are you using a Megasound board, as produced by HC1969?
Is it connected using serial (trim switches moved), or parallel?
Mike.
Re: Build Compile amod [Please help]
Posted: Wed Nov 15, 2017 5:00 pm
by darozas
MikeB wrote: ↑Wed Nov 15, 2017 4:03 pm
Are you using a Megasound board, as produced by HC1969?
Is it connected using serial (trim switches moved), or parallel?
Mike.
I have "Oliver PCB " design here.
While back you helped me to solve the issues I was having with it.
Its runs over serial . Yes trim switches moved. If I turn on off on quick it stops working no Backlight no sound
Regards
Re: Build Compile amod [Please help]
Posted: Wed Nov 15, 2017 5:03 pm
by jhsa
Mike, could it be that is starting in bootloader mode somehow?
I remember reading about the same problem a few years ago, but can't remember what caused it or what the solution is
João
Re: Build Compile amod [Please help]
Posted: Wed Nov 15, 2017 10:40 pm
by MikeB
Could be, that is controlled by the state of the serial Rx input at power on. If the serial Rx pin is low at power on, then the board starts in the bootloader.
I can't make either of my er9x radios fail in this way.
Mike.
Re: Build Compile amod [Please help]
Posted: Thu Nov 16, 2017 8:54 am
by darozas
Well nothing to worry it works!!!. I just don't turn on off quick. It wont effect radio from functioning so im fine.
Anyways got new radio coming so don't really worry about this at all.
Keep it up Mike !!!