openrcforums

MikeB wrote: ↑Tue Jul 14, 2020 9:04 pm New test version posted. I checked the operation of the external module using my T16.
The protocol editing menu has a lot of debug down the right side, I'll only need what that contains if it doesn't work!

Mike

Mike the module still fails to flash the firmware and will not bind any Receivers, it will however power off when you select a model that uses the internal module. When the flash fails it would appear to not upset the multi module as it continue to work in my X7.

Dave

Edit: Even when I bound a Rx to the multi module on my X7 and I then transferred the module to the X10S it failed to work.

The debug columns are
Col 1 Col 2
0003
0003
0002 36B0
0000 04-- to 1B--
0001 2710
0002 0100
0000 0030
counting up 0804
counting up 0001
064B 4645
counting up
0001
0002

I hope this helps

New test version posted. I think I may have this working except for PPM on the external module. I flashed the firmware to my T16 and the output looks OK, except for PPM which only works sometimes!

Mike

MikeB wrote: ↑Wed Jul 15, 2020 3:34 pm New test version posted. I think I may have this working except for PPM on the external module. I flashed the firmware to my T16 and the output looks OK, except for PPM which only works sometimes!

Mike

Thanks Mike it appears to be working, I bound a couple of different receivers, I will flight test it either today or tomorrow. I did not attempt PPM as i never use it.

Dave

Good! I have the fix for the PPM now. If you have a chance could you also try flashing the module?

Mike

Mike, would it be possible to have the scanner on the other older boards? AR9x, 9Xtreme, etc? Thanks.

João

Yes, it is in the source code for all radios/boards, I just need to get to a point where I can post a new test version for everything.

Mike

Thank you, I guess I will have to update my multi modules to the latest then
I am normally quite afraid to do that, specially in the middle of the season

João

MikeB wrote: ↑Thu Jul 16, 2020 8:49 am Good! I have the fix for the PPM now. If you have a chance could you also try flashing the module?

Mike

Hi Mike, the module flashes fine. Once again thanks for all your time and effort it is much appreciated.

Dave

I've now posted R223A3 test version for all radios. This has the changes in for the X10S external module, which should be fully working without all the debug. The MPM scanner display is also included for all radios (except the SKY board).

Mike

MikeB wrote: ↑Fri Jul 17, 2020 4:11 pm I've now posted R223A3 test version for all radios. This has the changes in for the X10S external module, which should be fully working without all the debug. The MPM scanner display is also included for all radios (except the SKY board).

Mike

Thanks Mike, I will install it in the morning.

Dave