Hi, I am using er9x, SVN: er9x-r813, VERS: V1.275-Mike and recently noticed that the trims on my Tx are not working as expected.
My Tx is Mode 1 and the er9x mix settings are CH1: +100%RUD, Ch2: +100%ELE, CH3: +100%THR, CH4: +100%AIL
This all works perfectly with my Rx which has Ch1: connected to Aileron servo, Ch2: connected to Elevevator servo, Ch3: connected to Throttle ESC and Ch4: connected to rudder servo.
However, when I use the rudder trim, located below the left stick on my Tx, the aileron setting is trimmed and when I use the aileron trim, located below the right stick on my Tx, the rudder setting is trimmed?
This is extremely confusing and is not what I would expect. Any help would be appreciated.
Regards
Trevor
Trims not working as expected
Re: Trims not working as expected
Hi, I am replying to my own question. I discovered that I had the CrossTrim setting set to ON in the Txs SETTINGS / Controls menu. Turning that OFF solved the problem The flexibility of er9x is amazing but can be full of traps for new players like myself.
Regards,
Trevor
Regards,
Trevor