FlySky FS-TH9X firmware and eeprom for flashing

[Davidjek]

After many hours of searching I finally found the "FlySkyV2" firmware for putting your Flysky transmitter back to factory configuration. I don't think the eeprom.bin file is the one that came with the V2 firmware but it is in the same format and it works. Funny thing, Companion9x will not burn the eeprom.bin file to the transmitter but eePe will. Also interesting is the fact that eePe will read the eeprom.bin from the tx and save to a file, but it will not read the file for editing. It will burn the file to the tx. So here it is, the V2 firmware and eeprom for the fs-th9x.

FlySkyV2Firmware.zip

(30.19 KiB) Downloaded 713 times

[Rob Thomson]

Lol..

You should have asked.

Its on the stock firmware section of this forum

Sent from my GT-I9300 using Tapatalk

[rainless]

Lol..

You should have asked.

Its on the stock firmware section of this forum

Sent from my GT-I9300 using Tapatalk

Nope! That's the Turnigy stock... not the Flysky stock.