Hello All!
Got my Taranis yesterday and everything works except the high precision Vario. The GPS sensor works fine, all 5 receivers range checked and are delivering telemetry.
Here’s how I have the Vario set which I’m pretty certain is correct:
CF1 Up Arrow Vario
I’ve got the Vario sound turned up and I’ve selected Vario as the “Source” under the Telemetry page. The recommended sensitivity is 0.3. I’ve dropped it all the way down to .1 and can’t get a peep out of it. It blinks, but won’t respond to any type of movement or blowing air on it. If I set the sensitivity to 0.0 the transmitter sounds off pretty much continuously. I also reset the telemetry page and entered my settings again.
In short: The Vario Blinks but doesn't respond to any type of pressure change. Me thinks it's defective.
TIA
Fred
Can't get my HighPrec Vario to peep!
-
- Posts: 10
- Joined: Thu May 29, 2014 3:53 pm
- Country: -
-
- Posts: 10
- Joined: Thu May 29, 2014 3:53 pm
- Country: -
Re: Can't get my HighPrec Vario to peep!
Never mind. Figured it out and all is well! Thread closed...
Re: Can't get my HighPrec Vario to peep!
Would you mind sharing how you fixed it with us? ![Wink ;)](./images/smilies/icon_e_wink.gif)
Thanks.
João
Sent from my GT-I9195 using Tapatalk
![Wink ;)](./images/smilies/icon_e_wink.gif)
Thanks.
João
Sent from my GT-I9195 using Tapatalk
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW