RCHH wrote:Is there any way to rename ELE in the SWCH selection? Or maybe have an IDy for what could be now known as the ID3/4/5 switch?
As João says, you are able to use any of the switches as source, including ELE whether it is 2 position or 3 position.
Now did you want/need a third 3-position switch? (or a fourth?).
You can change RUD or THR to 3 position now. Use the wire that was the ELE switch signal. Replace one of those two switches with a 3-position switch, connect the centre (common) switch pin to ground, and the outer two pins, one to the RUD or THR signal and the other to the now unused ELE signal. Then just set the switch to 3-POS in the hardware menu.
On the other side, you can change either AIL or GEA to 3-POS. For the extra input you use DAC1, which you can find on J23 pin5 on the Rev B board (J11, pin 5 of the ver 3 board).
You can only make RUD or THR into 3-POS when you have done the ELE mod, but the AIL/GEA change can be done anytime.
Mike.