Here it is. The code is ported from gv9x. Please tell-me if it works, I don't own the module to test myself...
Thanks,
Bertrand.
Binary with Mavlink extension for beta testing
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Binary with Mavlink extension for beta testing
- Attachments
-
- open9x.hex
- (164.56 KiB) Downloaded 425 times
Re: Binary with Mavlink extension for beta testing
Screen 1 INFOS is correct so 38kb is working. I see the APM2 boot up properly and get the heartbeat indication
Screen 2 does not display any data. all fields are 0
Screen 3 is getting proper data.
Earl
Screen 2 does not display any data. all fields are 0
Screen 3 is getting proper data.
Earl
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: Binary with Mavlink extension for beta testing
So no GPS information, right?
Bertrand.
Bertrand.
Re: Binary with Mavlink extension for beta testing
went back to gv9x109dump and all is ok.
btw...i did not notice a baud rate selection
earl
btw...i did not notice a baud rate selection
earl
Re: Binary with Mavlink extension for beta testing
just no gps info. baud must be 38kb cause that is whay my xbees do.
earl
earl
Re: Binary with Mavlink extension for beta testing
i would like to see the display screens more like my old stile with double character hight and 10 screens. easier to read at a glance.
earl
Here is old post
http://diydrones.com/profiles/blogs/tel ... -tx-screen
earl
Here is old post
http://diydrones.com/profiles/blogs/tel ... -tx-screen
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: Binary with Mavlink extension for beta testing
Ah ok, good explanation, I didn't ported it ...uphiearl wrote:just no gps info. baud must be 38kb cause that is whay my xbees do.
earl
I will do next week then.
Bertrand.