P1 and 2 are mixed

[Norbert]

Hi,

just programmed my 9X with ER9x and play around with it. I've assigned Ch5 to Ch7 to P1 to 3, starting from the plain 4Ch template.
So no mixers should be active.
But P1 and 2 are mixed together somehow, each with about 10% to the other.
Even in the simple 4-Ch-Mode I can see this mixing on the bars for the potis on the main screen, so it directly at the input of the potis and not a mysterious mixer.

What's that?

By the way: Thanks for making this software. As far as I see it's usability is unbeaten, can't be better. Great job, I just need to find where to make a donation...

Best regards,
Norbert

[jhsa]

Hi Norbert,
Theres a "Donate" button at the bottom of this page..

Try to create a new model in another slot and see if it still happens.

Be very welcome to the openRCforums. Your first few posts might have to be moderated and will not show immediately. Please be patient and don't double post someone will approve them when possible
Enjoy the forum

João

[MikeB]

Even in the simple 4-Ch-Mode I can see this mixing on the bars for the potis on the main screen, so it directly at the input of the potis and not a mysterious mixer.

Just checking, is this the three vertical bars showing P1 to P3 inputs?

Check the 12 way connector is properly in its socket.

Mike.

[Norbert]

Hi,

you guys are great. Just donated some...

Mike was right, it was the connector, now it works like expected.

Thanks a lot!

Norbert

[jhsa]

Great that you fixed it

João