Hello
I bought last week at HobbyKing following module for my Turnigy9x "FrSky DF 2.4Ghz Combo Pack for JR w/ Module & RX"
Link: -> http://www.hobbyking.com/hobbyking/stor ... le_RX.html
To bind the receiver and the controller go super
It occurs 2 problems
First The switch "THR CUT" and "AIL" do not work
Second The telemetry data is not displayed
What am I doing wrong?
Fr SKY DJH
Fr SKY DJH
Last edited by CAOS on Fri Nov 30, 2012 7:46 pm, edited 1 time in total.
Re: Fr SKY DJH
You're using the frsky version of the firmware but haven't done the telemetry mod. Use the normal version.
Sent via mobile
Sent via mobile
Re: Fr SKY DJH
I'm using firmware version FrSky Open9x for '9 X radios with Fr-Sky telemetry modification
The display is always "NO DATA"
The display is always "NO DATA"
Re: Fr SKY DJH
Yes, if you want telemetry you have to do these modifications:
http://openrcforums.com/wiki/index.php/ ... _telemetry
If you don't do them, use the normal firmware (NOT FrSky).
http://openrcforums.com/wiki/index.php/ ... _telemetry
If you don't do them, use the normal firmware (NOT FrSky).
Re: Fr SKY DJH
Thank you for your reply
The modification with the 2 resistors is yes OK
But where do I have FrSky Rx and Tx FrSky solder.
The FR-SKY-DJH's all a cartridge
I still installed inside this board and a soldering is not possible otherwise get nothing around contact pins
The modification with the 2 resistors is yes OK
But where do I have FrSky Rx and Tx FrSky solder.
The FR-SKY-DJH's all a cartridge
I still installed inside this board and a soldering is not possible otherwise get nothing around contact pins
Last edited by CAOS on Sat Dec 01, 2012 9:56 am, edited 1 time in total.
Re: Fr SKY DJH
CPU -> level converter (frsky upgrade lite as shown in the guide, or equivalent) -> RXD/TXD pins on the back of the module.