Trims control new channel

openTx has introduced a range of new features, ideas and bling. It is fast becoming the firmware of choice for many users. openTx will run on ALL current hardware platforms, including the gruvin9x and sky9x boards. Work has already started to support the new FrSky X9D radio!
Post Reply
scaleflyer
Posts: 1
Joined: Wed Jan 04, 2023 12:45 am
Country: -

Trims control new channel

Post by scaleflyer »

Okay, here's a new one!
I want to install servo-operated elevator trim tabs; ie. the elevators will not move to achieve trim, the elevator trim tabs will trim independently of elevator movement. What I want to know is this... is there a way to program the elevator trim switch to control the trim servos on another channel and NOT move the elevator servo normally associated with the trim switch? I want the switch to act as it normally would for trim but on a new channel.

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Trims control new channel

Post by Kilrah »

Yes, just assign the trim as source to that channel (and disable trim on the elevator mix).
Post Reply

Return to “openTx”