THR. CUT and AIL. D/R not working

isvedic · Post by **isvedic** » Sun Jul 01, 2012 4:04 pm

Hi,

My THR. CUT and AIL. D/R switches are not working after doing hard-wire upgrade and flashing open9x to my 9X.
Tried flashing ER9x but same, swithes are always off. In diagnostic mode that switches never became active.
Was extra careful when doing hardware mod, and yea, did sound and haptic mode too, that works perfectly

Checked wires, plugs all looks fine...

Post by **Crucial** » Sun Jul 01, 2012 4:59 pm

Sounds like you flashed the FrSky version of the software without doing the necessary mods for that version. The FrSky version of the software requires moving 2 signal connections. Those connections just happen to be the ail and thr cut switch.

isvedic · Post by **isvedic** » Mon Jul 02, 2012 7:15 am

Thanks, problem solved.

openrcforums