Hi I tried to set up yaapu on Taranis x9d+ 2019. On the Telemetry screen I can see the sensor data, but in the yaapu not.
What im doing wrong?
Possibly worth to mention that there is no luac switch at firmware install on this model.
See also the attached photo.
Thanks Szabolcs
Sent from my LG-H930 using Tapatalk
Yaapu on tarania x9d+ 2019
Re: Yaapu on tarania x9d+ 2019
Yaapu telemetry does not use standard telemetry, it uses passthrough telemetry which requires specific configuration on the flight controller and an adapter between FC and receiver.
https://ardupilot.org/copter/docs/commo ... assthrough
https://ardupilot.org/copter/docs/commo ... assthrough
Re: Yaapu on tarania x9d+ 2019
Hi
I set the serial protocol i used the converter modul.
And as i wrote the telemetey data arrives to the taranis, since on the 13 screen telwmtey i can see the swnsor data. Only i cant see on yaapu screen.
I installes the firmware with lua option. I set the yaapu screen. I copied the yaapu files to sd card.
Just cant see the telemetry data on yaapu screen.
Sent from my LG-H930 using Tapatalk
I set the serial protocol i used the converter modul.
And as i wrote the telemetey data arrives to the taranis, since on the 13 screen telwmtey i can see the swnsor data. Only i cant see on yaapu screen.
I installes the firmware with lua option. I set the yaapu screen. I copied the yaapu files to sd card.
Just cant see the telemetry data on yaapu screen.
Sent from my LG-H930 using Tapatalk
Re: Yaapu on tarania x9d+ 2019
Finally solved. I had to copy the new sd card content. It seems now everything is ok
Sent from my LG-H930 using Tapatalk
Sent from my LG-H930 using Tapatalk