FrSky RX6R
-
- Posts: 5
- Joined: Tue Dec 24, 2019 4:13 pm
- Country: -
FrSky RX6R
Hello everyone, 2 days ago i got my first frsky RX6R receiver. I successfully connected it with my transmitter (FrSky x9 lite pro) with PWM signals. It worked. Than i wanted to connect it with Sbus signal and since then it bricked. When i connect it to 5v and ground it turns on for a second with solid blue and red, and than turns off, i am not able to connect. Even in instruction is no information about red and blue diode configuration. Im able to enter bind mode but my transmitter do not see it. I am able to upload software on it through my transmitter. I am not experienced in rc connections, and i do not know what is going on. Could you help me with my problem? If you solve it i will give you a gift <3
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: FrSky RX6R
What firmware have you flashed to the RX6R?
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 5
- Joined: Tue Dec 24, 2019 4:13 pm
- Country: -
Re: FrSky RX6R
All firmwares available on frsky site(eu and lbt too), always turns off, green light never turns on, i have opened the cardboard and nothing looks like burned here, smell is okay too. Do you have any ideas what could happen?
Re: FrSky RX6R
Could you share some more imfo, maybe a picture on how you connected?
Re: FrSky RX6R
Mine did this. Try putting the rx into bind mode first then turning on the tx and going into bind mode. No idea why this worked, I am not technically minded, but it did.