I've had an XJT module in a TH9x with an AR9x board for a long time. Recently the XJT stopped working. When I power up the radio the red and green LEDs on the module are both on steady.
I cannot put the module into bind mode.
I have tested this module in a QX7 and a Jumper T12 with the same results.
I have also flashed the latest firmware. The flash was successful, but the module refuses to function.
Is there any hope, or do I need to replace it?
TIA..
FrSky XJT module. Is it dead?
- MikeB
- 9x Developer
- Posts: 17996
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: FrSky XJT module. Is it dead?
Have you tried putting it into bind mode by holding the button pressed while powering on?
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!