EZFlex2 Flex Plate from TH3D (CR10 3D Printer)
https://www.th3dstudio.com/product/ezfl ... i-coating/
The size I purchased for my CR10 3D Printer was the 310 mm X 320 mm cut size,
which is the best cut size for the CR10 Printer.
This new TH3D product is a big help for several reasons.
1) If you have a print surface of glass, you can throw it away
and so loosing the weight of it.
2) You can choose a print surface which works much better than glass.
3) With the Flex Plate removal of the finished Print is a lot easier.
4) A lot less trouble and messing around using hair spays, glues and tape.
5) You can apply other build sheet if you like, like the EZMat sheet.
You may also, want to purchase the EZFlex² Magnetic Base (140C Max Temp).
https://www.th3dstudio.com/product/ezfl ... etic-base/
This is a big help, as no more clips to hold the print surface in place.
When you receive your new EZFlex2 Flex Plate, it is helpful to deburr the edges.
I used a small electric hand belt sander and a find grit stone to give a nice
finished edge after removing the cut size burr.
See here for a bundled packaged,
EZFlex² – Flexible Print System: https://www.th3dstudio.com/product/ezfl ... nt-system/
Also, if you do the "Increase Y-axis Print-Bed Travel Mod (CR10 3D Printer)"
with using the EZFlex² 310mm X 320mm cut size,
you will be able to increase the Y-axis Print Area of your CR10 Printer.
See here: https://openrcforums.com/forum/viewtopi ... 97#p147097
EZFlex2 Flex Plate from TH3D (CR10 3D Printer)
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
EZFlex2 Flex Plate from TH3D (CR10 3D Printer)
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).