Hi guys!
My radio currently only recognizes S1, S2, RS, and LS (which are all POTS) as available input sources on the radio. If I long press menu to get into the radio settings and page over to the HARDWARE tab, every single switch (SA-SH) is listed as NONE.
I noticed this after doing a firmware update but after reading some forums, this seems to be a hardware issue? Has anyone seen this before?
Radio used to work fine, and I've flown with this radio for hundreds of hours. Any help would be greatly appreciated!
v/r/Jay
X9D+ not recognizing switches SA-SH
Re: X9D+ not recognizing switches SA-SH
Just set them back to the correct type...
Re: X9D+ not recognizing switches SA-SH
How? It doesnt let me change the settings in the hardware menu. It says that those values are read in from the radio.
Re: X9D+ not recognizing switches SA-SH
You can change them both in the radio and companion
Re: X9D+ not recognizing switches SA-SH
Can you tell me how to do that?
Re: X9D+ not recognizing switches SA-SH
Just change the value? Don't get what you need... Please post what makes you think you can't.
Re: X9D+ not recognizing switches SA-SH
Finally figured out what I was doing wrong. I didn't realize I could tab over to that value field in the HARDWARE menu as I thought it was a read-only field. I was wrong. Thanks so much for your help @Kilrah!