Mike will erskyTx be able to run on the new x9d plus 2019 ?
Thanks
Allen
Taranis X9D Plus & SE 2019
-
- Posts: 238
- Joined: Tue Dec 25, 2018 3:19 am
- Country: United States
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Taranis X9D Plus & SE 2019
|I'm just about to start on porting ErskyTx to this.I haven't had any advanced notice it was coming out and I've only just received technical documentation to enable me to get started. I may well need to buy a radio as well to make sure all is working.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 238
- Joined: Tue Dec 25, 2018 3:19 am
- Country: United States
Re: Taranis X9D Plus & SE 2019
Frsky needs to send you a radio with all you have done . I can at least send you some beer money while your getting it ported .
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Taranis X9D Plus & SE 2019
Thank you.
I make it 21 pins on the processor have changed function, and I need to get the ACCESS code enabled. Hopefully, most of the changes won't take too long, just a matter of enabling the correct bits of code.
Mike
I make it 21 pins on the processor have changed function, and I need to get the ACCESS code enabled. Hopefully, most of the changes won't take too long, just a matter of enabling the correct bits of code.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 238
- Joined: Tue Dec 25, 2018 3:19 am
- Country: United States
Re: Taranis X9D Plus & SE 2019
I did not know I could add a rotary encoder to my x9d plus and not lose a pot . Mike I read a post you had on another forum . I have encoders on my pro's and always wanted one on my Taranis . That would be the only reason I would buy the new Taranis is for the roller but I can just add encoder to my x9d plus
Allen
Allen