So I need a 4th pot on my 9x pro .I have used the spare dig for a 3way switch . Can I use the spare ana for the fourth pot ? And how ? I have installed the encoder and it works great (Thanks so much for the help on that)
Thanks
Allen
4th pot
-
MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 4th pot
Yes, the spare ANA input is on J3. pin 2. Analog 3.3V is on J3 pin 1, and ground is on J3 pin 5.
For a pot, you will need to remove R83 and R90 (both 2K2) as these provide a potential divider so the signal could be used as a 3-pos switch input. Also make sure R22 (100R) is present, or solder a wire across it.
Wire up the pot, then go to the Hardware menu and set pot 4 to AD10.
Mike
For a pot, you will need to remove R83 and R90 (both 2K2) as these provide a potential divider so the signal could be used as a 3-pos switch input. Also make sure R22 (100R) is present, or solder a wire across it.
Wire up the pot, then go to the Hardware menu and set pot 4 to AD10.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
antlerhanger
- Posts: 238
- Joined: Tue Dec 25, 2018 3:19 am
- Country: United States
Re: 4th pot
Thank you so much . You my friend , are amazing !! .
Allen
Allen